| Linux, FreeBSD, Juniper, Cisco / Network security articles and troubleshooting guides https://forum.ivorde.com/ |
|
| Junos "show bgp summary" shows different outputs for neighbors https://forum.ivorde.com/junos-show-bgp-summary-shows-different-outputs-for-neighbors-t19851.html |
Page 1 of 1 |
| Author: | admin [ Tue Jun 14, 2016 2:56 pm ] |
| Post subject: | Junos "show bgp summary" shows different outputs for neighbors |
The "show bgp summary" in Junos shows all configured or established neighbors (there can be RR clients that are not configured, but are established). More information about output of "show bgp summary" is documented on Juniper website: http://www.juniper.net/documentation/en_US/junos15.1/topics/reference/command-summary/show-bgp-summary.html The output includes both internal and external neighbors with a small difference. Internal neighbors (even they only use ipv4 unicast AFI/SAFI) show up as "ESTABL" and a line below shows the RIB and statistics. For external BGP neighbors, the statistics are shown on the same line as the neighbor. Code: [edit protocols bgp] admin@PPPPP# run show bgp summary Groups: 2 Peers: 3 Down peers: 0 Table Tot Paths Act Paths Suppressed History Damp State Pending inet.0 1 1 0 0 0 0 inet6.0 1 1 0 0 0 0 Peer AS InPkt OutPkt OutQ Flaps Last Up/Dwn State|#Active/Received/Accepted/Damped... 10.0.255.3 1234 2 4 0 1 5 0/0/0/0 0/0/0/0 10.0.255.7 65000 45 46 0 0 19:18 Establ inet.0: 1/1/1/0 2000:dead:beef:255::7 65000 46 46 0 0 19:22 Establ inet6.0: 1/1/1/0 10.0.255.3 is eBGP 10.0.255.7 is iBGP. This is most probably because L3VPN and L2VPN routes (bgp.l3vpn.0 RIB) are exchanged over internal BGP sessions and this output is optimized to better account for this fact. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|